golmar Rock Serie Manual De Instalación página 85

84
Example of cascade connected devices.
Remove jumper JP1 of all EL562 circuits
from monitors (see pa
except from the one in which the
twisted pair end is located.
Example of distribution connected devices.
Remove the end of line jumper from all the
distributors (JP1) and all EL562 (JP1) from
monitors, except from those ones in which
the twisted pair cable end is located (without
using output).
If your device is equipped with just one door panel,
do not consider connections to other door panels.
If your device is equipped with more than one door panel,
connect the other door panels as shown in the picture.
IMPORTANT NOTE
When using a d.c. lock release, just 2 wires are
needed between power supply and door panel.
Refer to diagram on page 80.
FA-805
PRI SEC
+ -
230 110 0 ~ ~
Main
INSTALLATION DIAGRAMS
ge 69),
PVS-295SE
-
V V V V + A
out- out+ in+ in-
M
-
A D CV1 CV2
out in
Tekna Plus
RCTK Plus
EL562
JP1
_
+ V M
A D
p
p
Vca.
Lock release