Tabla de contenido
Publicidad
Trigger the accessory and digit a name for the accessory (max 10 characters). [EG
remote control: push a button].
Set the trigger modes or other properties as you need, then save.
Click Accessory->Remote controller or Security Accessory: Show names of
paired accessories and their trigger modes.
If you are adding an already paired accessory, +Alarm
App will show an alert.
When pairing with Smart Switch or Wireless Siren, please
power it up before saving pairing settings.
Door Sensor:
Open the case and remove the battery insulative
strip.
Make sure the distance between transmitter and
magnet is less than 1cm and at the same level.
Trigger: remove A from B of at least 3 cm (the red
light is on for a few seconds).
PIR Sensor:
Open the case and remove the battery insulative
strip.
Avoid installing two sensors in the same detection
scope to interference.
Indoor use only. Avoid installing the sensors in area
with strong light, temperature changes rapidly or the
air stream flows frequently, like close to windows, air
conditioner, refrigerator, heater, oven, and large
obstacles.
Trigger: move an object in front of PIR (the red light
is on for a few seconds).
57
ENG
Publicidad
Tabla de contenido
