Playcore Swing-N-Slide 5' Turbo Tube Slide Instrucciones De Montaje página 13

ssembly Instructions
5' DECK HEIGHT
2-1/2'' screw
Slide Barrier Construction
1. Carefully remove your Barrier Support Boards
from the barrier where you would like to place
your slide, making certain you will have a clear
72'' Safety Zone for your slide. (Fig. 6).
Retain this lumber and fasteners as you will need
them in a later step.
2. Cut to length and install (2) 2'' x 4'' Barrier
Support Boards as shown in (Fig. 6a), making
certain the opening between them is 25''.
3. Cut (1) 2'' x 4'' Barrier Board to the height of
your barrier railing and create a slide opening of
23'', as shown in (Fig. 6a).
4. Reattach your barrier boards, making certain
they are evenly spaced and do not have a gap
larger than 3'' between each board, as shown in
(Fig. 6a).
Fig. 6
This plan uses a generic tower to
illustrate the 5' Turbo Tube Slide being
attached. However, this same procedure
is to be used for any Swing-N-Slide
5' Tower Playset.
screws
Fig. 6a
per joint
13
ssembly Instructions
NOTE:
3-1/4'' Gap
Between Each
(3) Barrier Board
2-1/2''
2'' x 4''
Barrier Board
Cut to Height
of Rail
per barrier
25''
(4)
2-1/2''
screws
board