Playcore Swing-N-Slide 5' Turbo Tube Slide Instrucciones De Montaje página 9

Fig. 2
FlANGE DETAIl
ELBOW ND EXIT SECTION
1. Assemble the Elbow Section by securing as shown in
(Fig. 2) and (Fig. 2a). Join sections using a hex head
bolt, two flat washers, and a loc nut at each hole
junction.
NOTE: Fasten each loc nut finger tight. Each time you
join parts be sure each flanged lip is mating with a flat
lip.
2. Repeat step 1 to assemble (3) remaining Elbow Sections.
3. Assemble and secure the Exit Section as shown in
(Fig. 2a) and (Fig. 2b). Make certain to attach the
Elbow Support Bracket to the bottom of the flange,
as shown in (Fig. 2b).
4. Tighten all hardware.
NOTE: Interlocking design of flanges on Elbow pieces
will assist in assembly.
x4
Elbow Section - 9 bolts each
Flange Opening
SSEMBLY
Fig. 2b
Exit Section - 9 bolts
9
ssembly Instructions
Fig. 2a
Hex Head Bolt
Washer
Washer
Loc Nut
Elbow Support
Bracket