Follett SmartGATE A36000 Manual De Instalación página 5

Reinstalling door assembly
1. Reinstall lower door assembly in bin opening.
2. Reinstall three or four (3 or 4) screws in hood at top of door assembly.
3. Reinstall SmartGATE ice shield in side panel tracks and push down to seat.
4. With door closed insert one door stud through hinge bracket.
Note: For proper operation the access door must be reinstalled in the closed position.
5. On other side, insert screwdriver between door and hinge bracket and gently push against bracket to provide
room for door stud to clear bracket.
6. Reinstall washers and screws in lift door and tighten.
7. Check door to ensure proper operation.
Ice guide adjustment
Some ice types are very "slippery" and may flow over sides of cart when exiting hopper. Ice guides hang down
below hopper and help contain flowing ice inside cart.
Guides are installed in highest position at factory, providing 19 mm (3/4") clearance to top of cart when
legs are in full down position. If legs are adjusted up during leveling of Ice Transport System, ice guides
should be lowered to maintain 19 mm (3/4") clearance. Access to sides of Ice Transport System is required
to perform operation.
To reposition ice guides after legs have been adjusted:
1. Position cart (with Totes
2. Determine amount guides must be lowered to maintain 19 mm (3/4") clearance.
3. Remove thumbscrews holding guides.
4. Select hole to reposition guide at proper level and resecure with thumbscrew.
5. Repeat process for each bay in system.
brackets on underside of hopper to which
ice guides are secured
™ ice carriers, if so equipped) in bay below shutter door opening.
5