Kasco 8400EJF Manual Del Propietário página 6

Mounting Bracket between the Cage and Fountain
Housing, you can use a screwdriver to gently pry open
enough space.
STEP SIX (For 3.1EVFX models)
Return the assembly to the upside down position and
place the motor assembly (Stainless Steel can side
up, black tube down) in the center of the fl oat. Align
the 3 taller legs of the black fountain tube with the 3
fl oat brackets. Attach the motor to the fl oat using the
1/4" x 1" bolts. Attach to the fl oat bracket using the
two middle holes of the fl oat bracket. Tighten us-
ing the 1/4" x 1" Bolts with 1/4" Lock Washers using
the 7/16" socket and wrench. The 1" bolts will screw
directly into the legs of the black fountain tube.
STEP SEVEN
Position the Bottom Screen (Part B9) over the fl oat so
the motor housing (can) passes through the large hole
in the center of the screen. Remove the center three
Lock Nuts from the 9" Bolts and place the Bottom
Screen Clips (Part B13) over the bolts as shown. The
power cord can be slid under the bottom screen where
two fl oat sections come together before the Lock Nuts
are replaced. Replace the three inside Lock Nuts and
tighten all 3/8" Lock Nuts using the 9/16" (14mm)
wrench and socket.
6
Note: Extra hardware may be included
STEP EIGHT
Return the unit to its upright position and select a
nozzle (See Nozzle and Pattern Options). Select the
proper Shaft Bolt (Part D2) and insert the Shaft Bolt
into the Nozzle Head so it fi ts snugly into the molded
socket. Install the Nozzle by threading it into the inner
cone of the pump. Make sure to tighten the Nozzle all
the way down.
To install the Redwood nozzle, make sure the Y Insert
(Part D4) is installed and seated properly into the
nozzle. Push the nozzle down over the cone assembly
(it may require light taps with a rubber mallet to seat
properly). Next, use the 3 Self Tapping Screws (Part
D1) provided in the 3 holes on the nozzle and tighten
the screws into the cone assembly. Once you feel
resistance, two more turns will be suffi cient. To install
the Spruce nozzle, follow the same steps, but do not
install the Y Insert.
STEP NINE
The power cord should now be attached to the stub
cord by lining up the male and female halves of the
disconnect and hand tightening the blue collar. On
these cords, the Additional Strain Relief should be
attached to one of the lower fl oat brackets as pictured.
If there is not Strain Relief, use the Nylon Cable Tie
provided to secure the cord to a rope to prevent dam-
age by the propeller. If installing a new Quick Dis-
connect, please refer to Quick Disconnect instructions.