Starting And Stopping Your Engine - Tomahawk TOMAHAVK POWER TMD14 Manual De Usuario

STARTING AND STOPPING YOUR ENGINE

Starting Your Engine:
When starting the engine make sure the engine is fueled and the water
tank prepped for spraying.
1. Push the throttle lever to the on position marked (I).
2. Prime the engine 4-5 times, or until fuel is visibly passing
through the fuel lines. See Figure 1.
3. Move the choke to the closed position.
4. Pull the recoil starter until the engine fires.
5. After the engine starts, slowly move the choke to the open
position.
6. Let the engine idle for several minutes and then begin
spraying.
7. Open your water valve to start flow of liquid pesticide and
begin spraying. See Figure 2.
Stopping Your Engine:
1. Move the water valve to the closed position to stop the
flow of liquid pesticide.
2. Move the throttle lever to the down position (O) to stop the
engine.
3. Move the choke to the closed position.
15