EINHELL TC-TS 2225 U Manual De Instrucciones Original página 36

•
There is no push block supplied with the
saw! (Available from your specialist dealer).
Replace the push block without delay when it
becomes worn.
8.2 Making bevel cuts (Fig. 24) Bevel cuts must
always be used using the parallel stop (7).
If you tilt the saw blade (4) to the left when
making angular cuts, position the parallel stop (7)
on the right-hand side of the saw blade (4).
Anl_TC_TS_2225_U_SPK9.indb 36
GB
Guide the workpiece between the saw blade (4)
and the parallel stop (7).
•
S et the blade (4) to the desired angle. (See
7.5.)
•
S et the parallel stop (7) in accordance with
the workpiece width and height (see 7.3)
- 31 -
29.10.2019 11:29:11
29.10.2019 11:29:10