INTRODUCTORY COMMENT
This floor cleaning machine is
used for the industrial and civil
cleaning and is able to clean
any type of floor. During its for-
ward movement, the combined
action of the brushes and the
detergent solution removes the
dirt which is aspirated through
the rear suction assembly, giv-
ing a perfectly dry surface.
The machine must be used only
for such purpose. It gives the
best performance if it is used
correctly and maintained in
perfect efficiency. We therefore
ask you to read this instruction
booklet carefully whenever dif-
ficulties arise in the course of
the machine's use. In case of
need, we ask you to contact our
service department for all ad-
vice and servicing as may prove
necessary.
GENERAL RULES OF SECU-
RITY
The rules below have to be fol-
lowed carefully in order to avoid
damages to the operator and to
the machine.
- Read the labels carefully on
the machine. Do not cover them
for any reason and replace
them immediately if damaged.
- The machine must be used ex-
clusively by authorized staff that
has been instructed for its use.
- During the working of the
machine, pay attention to other
people and especially to chil-
dren.
- In case of danger act imme-
diately upon the emergency
brake.
- Leaving the machine in park-
ing position, take off the key and
act upon the parking brake.
- Do not mix different deter-
gents, avoiding harmful odors.
Do not place any liquid contain-
ers onto the machine.
- Storage temperature: between
-25°C and +55°C
(-13°F and 131° F).
- Perfect operating temperature:
between 0°C and 40°C (32°F
and 104°F).
- The humidity should be be-
tween 30 and 95%.
- Do not use the machine in
explosive atmosphere.
- Do not use the machine as a
means of transport.
- Do not use acid solutions in
such concentrations that could
damage the machine and/or the
persons.
- Do not use the machine on
surfaces covered with inflamma-
ble liquids or dusts (for example
hydrocarbons, ashes or soot).
- In case of fire, use a powder
fire-extinguisher.
Do not use water.
- Do not strike shelvings or scaf-
foldings, where there is danger
of falling objects.
- Adapt the working speed to the
conditions.
- Do not use the machine on
areas having a higher gradient
than the one stated on the num-
ber plate.
- The machine has to carry out
simultaneously the operations
of washing and drying. Different
operations must be carried out
in restricted areas prohibited
to non-authorized personnel.
Signal the areas of moist floors
with suitable signs.
- If the machine does not work
properly, check by conducting
simple maintenance proce-
dures. Otherwise, ask for tech-
nical advice to an authorized
assistance centre.
8
- Where parts are required, ask
for ORIGINAL spare parts to the
distributor and/or to an autho-
rized dealer.
- Use only ORIGINAL brushes
indicated in the paragraph
"RECOMMENDED BRUSHES
".
- For any cleaning and/or main-
tenance operation take off the
power supply from the machine.
- Do not take off the protections
which require the use of tools to
be removed.
- Do not wash the machine with
direct water jets or with high wa-
ter pressure nor with corrosive
material.
- Every 200 working hours have
a machine check through an
authorized service department.
- In order to avoid scales on the
solution tank filter, do not fill the
detergent solution many hours
before the machines' use.
- Before using the machine,
check that all panels and cov-
erings are in their position as
indicated in this use and main-
tenance catalogue.
- Be sure the recovery tank is
empty before lifting it.
- Restore all electrical connec-
tions after any maintenance
operation.
- Provide for the scrapping of
the material of normal wear
following strictly the respective
rules.
- When your machine has to
stop activity, provide for the
appropriate waste disposal of
its materials, especially oils,
batteries and electronic compo-
nents, and considering that the
machine itself has been, where
possible, constructed using
recyclable materials.