Product Description; Remote Control - TESY MC 20112 Instrucciones De Uso

3. Install the provided handle at the back of the appliance by
EN
fixing the two screws as shown (Figure 3) with 2 screws of
4*14 is fixed into the correspond hole.
Figure 3
•
This heater can be used also as a fixed appliance.
Intruction for fixing the heater on wall:
Picture 1
•
Take out 1 bracket (2pcs) / 2 bracket (1pc) / 4*14(4pcs)
screws of the accessories bag.
•
Install 1 bracket at the back of the appliance by fixing
the 4 screws (see picture).
•
Remove the middle one screw at the bottom of
appliance, and install 2 bracket here by fixing this one
screw.
Picture 2
•
Installing range for 1 bracket: 700mm
•
Use 6 pressing drill to drill out 1 bracket mounting
holes on the wall, fit the holes with colloidal
particles within the accessories bag, then fixing
screws 4*36 on the wall.
Note: Screw should appear 3-5mm
4
Usage and Storage Instructions
1
2
Picture 3
•
Hang the appliance on the wall; mark the 2 bracket
installation hole with pencil.
•
Remove the appliance, use 6 pressing drill to drill
out mounting holes on the wall, fit the holes with
colloidal particles.
•
Hang the appliance on the wall, fixing 2 bracket
with screws 4*36.
•
Wall-mounted installation finished.

PRODUCT DESCRIPTION

Front grill
Feet
Figure 5

REMOTE CONTROL

1. "ON/OFF", Power on and off.
2. "TIMER", 24hours timer to set.
3.
"SET", press this knob to select
the working mode: LOW power,
MIDD power, HIGH power ,
AUTO, Frost.
4. "UP+",increase the set
temperature or hour.
5. "DOWN-",decrease the set
temperature or hour.
Note: Install 2X1.5V (AAA) not included battery. All
the functions performed with the remote control
work identically to the manual controls
LED display
Control panel
On/Off switch
1
ON/OFF
2
TIMER
3
SET
4
UP+
5
DOWN-