Tabla de contenido
Publicidad
TERMINAL BOARD CONNECTIONS
1-2
230VAC
3-4
FLASHING UNIT
5-6-7
MOTOR M1
MOTOR M2
8-9-10
ELECTRIC LOCK
11-12
13-14
24Vac
15-16
OPEN LIMIT SWITCH
CLOSE LIMIT SWITCH
15-17
PHOTOCELL 2
15-18
15-19
STOP
15-20
PHOTOCELL 1
CLOSE
21-25
22-25
OPEN
STEP
23-25
PEDESTRIAN
24-25
25-15
COMMON
G.O. IND. LAMP
26-27
28-29
OUTPUT 2 CHANNEL
AERIAL
30-31
230Vac 50 Mhz mains power supply.
Outlet for flashing/courtesy lamp (selection between
flashing unit and courtesy lamp is set on the relative
J2 jumper) max. 230Vac 25W for flashing unit, max.
100W for courtesy lamp.
Output for motor 1 with delay on opening; time
interval is fixed at one second. 230Vac 400VA max.
Output for motor 2 delayed on closing by means of
trimmer TR of SKL-2. 230Vac 400VA max.
12Vdc output that remains active from 0.5 seconds
before to 4 seconds after start-up of motors on
opening. 15W max.
24Vac output for auxiliary power supply (photo,
radio etc.)
Input for open limit switch
input for close limit switch
Input for safety devices also on opening (photcells,
safety edges)
Input for stop command (emergency, external
safety lock)
Input for safety devices (photocells, safety edges)
Input for close command
Input for open command
Input for sequential operating mode (open stop
close stop)
Input for pedestrian command
Common entrance
Output for Gate Open indicator lamp 24Vac max 2W
Output 2° channel SK radio.
Input for radio receiver aerial
5
Publicidad
Tabla de contenido
