Kreisen KR-321T Manual Del Usuario página 32

- Connect the RS-232C input jack to an external control device (such as a computer or an A/V control system) and con-
trol the set's functions externally.
How to connect external control equipment
Connect the serial port of the control device to the RS-
232C jack on the set.
RS-232C connection cables are not supplied with the
Monitor.
The Monitor remote control and front panel controls
(except main power) will not be functional if the set is
controlled by a PC computer or other external device.
32
< Side panel of the set >
RS-232C INPUT RS-232C INPUT
RGB INPUT RGB INPUT AUDIO INPUT AUDIO INPUT DVI INPUT DVI INPUT
(CONTROL/SERVICE) (CONTROL/SER VICE)
Type of connector; D-Sub 9-pin male
No. Pin name
1 No connection
2 RXD (Receive data)
3 TXD (Transmit data)
4 DTR (DTE side ready)
5 GND
6 DSR (DCE side ready)
7 RTS (Ready to send)
8 CTS (Clear to send)
9 No Connection
Communication Parameters
• Baud rate : 115200 bps (UART)
• Data length : 8 bits
• Parity : None
• Stop bit : 1 bit
• Communication code : ASCII code
1
5
9
6