Additional Settings (Option) - Sony Trinitron CPD-G220 Manual De Instrucciones

Additional settings (OPTION)

You can manually degauss (demagnetize) the monitor, adjust the
moire cancellation level, reset to factory setting, and lock the
controls.
1
Press the MENU/OK button.
The main MENU appears on the screen.
2
Move the joystick m/M to highlight
press the MENU/OK button.
The OPTION menu appears on the screen.
3
Move the joystick m/M to select the desired
adjustment item.
Adjust the selected item according to the following
instructions.
Degaussing the screen
The monitor is automatically demagnetized (degaussed) when the
power is turned on.
To manually degauss the monitor, first move the
joystick m/M to select
joystick ,.
The screen is degaussed for about 5 seconds. If a second degauss
cycle is needed, allow a minimum interval of 20 minutes for the
best result.
Adjusting the moire*
If elliptical or wavy patterns appear on the screen, adjust the
moire cancellation level.
To adjust the amount of moire cancellation, first move
the joystick m/M to select
move the joystick </, until the moire effect is at a
minimum.
* Moire is a type of natural interference which produces soft, wavy lines
on your screen. It may appear due to interference between the pattern
of the picture on the screen and the phosphor pitch pattern of the
monitor.
Example of moire
12
OPTION and
(DEGAUSS). Then move the
(MOIRE ADJUST). Then
INPUT
1 2
Resetting the adjustment
The RESET option erases your customized settings.
To restore your monitor to the factory settings, first
move the joystick m/M to select 0 (RESET). Then move
the joystick , , to reset the adjustment for current
input signal. Hold the joystick , for 2 seconds to reset
the adjustment for all input signals.
Note
When "reset the adjustment for all input signal" is activated, the
customized language selection goes back to the default language of
English.
Locking the controls
To protect adjustment data by locking the controls, first
move the joystick m/M to select
Then move the joystick ,, to select ON.
Only the 1 (power) switch, EXIT, and
of the OPTION menu will operate. If any other items are
selected, the mark appears on the screen.
To cancel the control lock
Repeat the procedure above and set
(CONTROL LOCK).
(CONTROL LOCK)
(CONTROL LOCK) to OFF.