Truper CANT-8X-2 Manual Del Usaurio página 23

Assembly
I
7
Assemble the switch
module (I) in the jointer
using two sets of screws,
washers and pressure
washers.
9
Cutter head guard (K)
setup:
Remove the screw from
the guard pole through
the orifice in the in feed
table. Secure the guard
using the screw previously
removed from the pole
(L).
M
10
Assemble the knob (M)
in the pole set below the
out feed table and secure
with a screw.
H
L
12
Assemble the pedal to move the machine
(P) into the cabinet base using three sets
of screws, washers and pressure washers.
Assemble the rip fence (G) into the rip fence
6
support using two sets of screws, washers
and pressure washers.
Insert and thread the rip fence control
G
J
K
O
N
knobs (H) into the rip fence.
8
Fix the dust extraction
connector (J) using four
screws.
11
In fed table adjusting lever
(N) installation: Thread
the safety nut (O) in the
lever as deep as possible.
Thread the lever into the
block behind the in feed
table. Tighten the safety
nut against the block to
secure the lever.
P
ENGLISH
7