GRABBER GR871 Manual De Instrucciones página 7

MAXIMUM CUTTING CAPACITY
NOTE: Capacity shown on chart assumes no wheel wear and opti-
mum fence position.
Standard Equipment
1 14" (355 mm) metal cutting abrasive wheel
1 Allen wrench
1 Instruction manual
To Carry (Fig. 1)
Fold down unit to position where you can carry the saw. Push in lock
pin (A) to lock arm down.
Unlocking (Fig. 1)
To unlock tool and raise head, depress motor arm slightly and pull lock
pin (A) out. Motor arm will then pivot upward.
Material Clamping and Supporting
• Angles are best clamped and cut with both legs resting against
base.
• A spacer block slightly narrower than the workpiece can be used
to increase wheel utilization (Fig. 3).
• Long workpieces must be supported by a block so it will be level
with top of base (Fig. 4). The cut-off end should be free to fall
downward to avoid wheel binding.
FIG. 3
DIAMETER OF WORK PIECE
F
WIDTH OF SPACER BLOCK
FIG. 4
BLOCK
Spark Defl ector Adjustment (Fig. 1)
To best deflect sparks away from surrounding persons and materials,
loosen the screw (B), adjust the spark deflector (C) and then retighten
screw.
5
SPACER
E
BLOCK
CUT OFF
END