Handling And Use; Switching The Appliance On/Off; Air Outlet Valve - Silvercrest SLE 265 B3 Instrucciones De Uso

Handling and use

This section provides you with important information on handling and using the
appliance.
Switching the appliance on/off
♦ Press the STAND-BY button
You will hear a beep and the OPERATION LED
♦ Press the STAND-BY button
You will hear a beep and the OPERATION LED
NOTE
► The appliance starts in the mode last selected.
► After a power failure, if the appliance is disconnected from the mains, or
after switching off owing to the overheating protection, the appliance
restarts in the mode last selected.
♦ If a timer has been programmed, the appliance switches off definitively
upon lapse of the time specified (1–24 hours).
♦ If the relative humidity value has been defined in the TARGET HUMIDITY
programme, the appliance switches off once the value has been attained.
If the value is exceeded, the appliance switches on again.
♦ The appliance switches off if the water tank
If wrongly positioned, or if the water tank
FULL LED
NOTE
► The water tank
condensate cannot be collected properly.

Air outlet valve

to dry washing, for example. In this way, you can direct the air flow towards the
wet laundry.
SLE 265 B3
20
20
16
flashes and you will hear a beep if the appliance is switched on.
4
must be fully inserted in the appliance; otherwise, the
There is an adjustable valve
upper side of the appliance that you can open. You can
set the valve
flow. This can be helpful if you are using the appliance
to switch on the appliance.
19
lights up.
to switch off the appliance.
19
goes out.
4
is full or has been removed.
4
has been removed, the TANK
2
on the air outlet on the
2
at various angles to determine the air
37 ■
GB│IE
│