Milwaukee 6560 Serie Manual Del Operador página 5

Charge only MILWAUKEE 12, 14.4
and 18 Volt battery packs in
MILWAUKEE chargers. Other types
of batteries may explode causing
personal injury and damage.
Charge your battery pack before you use
your tool for the first time and when your
tool no longer performs with the power
and torque needed for the job. Never
completely discharge the battery pack.
Standard charging time will vary accord-
ing to the type of charger you use. The
charging time will also vary depending on
the supply voltage and charge needed. For
example, if your battery pack does not
require a full charge, charging time will be
less.
FOR SPECIFIC CHARGING INSTRUCTIONS,
PLEASE READ
OPERATOR'S MANUAL SUPPLIED WITH
YOUR CHARGER.
Battery packs are affected by tempera-
ture. Your battery pack will perform best
and have longest life if it is charged when
the temperature is between 60°-80°F (15°-
27°C). Do not charge in temperatures be-
low 40°F (5°C) or above 105°F (40°C).
Under these conditions, capacity will be
reduced. (See "Maintenance").
Removing Battery Pack from Tool
For all models:
Push in the release buttons and remove
the battery pack.
CHARGING & USING BATTERY PACKS
WARNING!
THE CHARGER
Inserting Battery Pack into Tool
For all models:
Battery pack can be inserted into the tool
in two ways.
1. For working in restricted spaces.
Insert the battery pack from the front
by pressing in the release buttons and
sliding battery pack into the body of
the tool (Fig. 1). Insert the battery pack
until clamp engages.
Fig. 1
2. For optimum weight distribution and
balance.
Insert the battery pack from the back
by pressing in the release buttons and
sliding the battery pack into the body
of the tool (Fig. 2). Insert the battery
pack until clamp engages.
Fig. 2
NOTE: A 12 volt battery is supplied with
this tool. To extend run time or increase
plunger speed, a 14.4 volt battery may be
used.
5