TFA 30.1046 Instrucciones De Uso página 5

TFA_No. 30.1046_Anleit_03_21
Digital shower thermometer
Caution!
Risk of injury:
• Keep this thermometer and the batteries out of reach of children.
• Batteries contain harmful acids and may be hazardous if swallowed.
If a battery is swallowed, this can lead to serious internal burns and
death within two hours. If you suspect a battery could have been
swallowed or otherwise caught in the body, seek medical help imme-
diately.
• Batteries must not be thrown into a fire, short-circuited, taken apart
or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent
damage caused by leaking. Never use a combination of old and new
batteries together, nor batteries of different types.
• Wear chemical-resistant protective gloves and safety glasses when
handling leaking batteries.
Important information on product safety!
• The response time for a steady temperature measurement is up to 4
seconds.
• Do not expose the thermometer to extreme temperatures, vibrations
or shocks.
5. Elements (Fig. 1)
A 1: Shower hose
A 2: Screw connection
A 3: Sealing ring
A 4: Display: water temperature in °C
A 5: Shower thermometer
A 6: Screw cap
A 7: Screw connection
A 8: Shower head
6. Getting started
• Open the battery compartment at the rear of the thermometer using
a screwdriver. Remove the battery compartment lid by inserting a
pointed object into the small opening.
• Remove the insulation strip.
• Carefully screw the battery compartment lid back on.
Caution: make sure that the screw is tight so no water can get inside.
8
28.03.2021 13:57 Uhr Seite 5
Digital shower thermometer
7. Installation
This shower thermometer is suitable for all standard shower devices. If
you have any problems with its installation, please consult your
plumber.
1. Take the sealing-ring out of the screw cap.
2. Remove the shower head from the shower hose.
3. Screw in the shower thermometer between the shower head and the
shower hose, as shown in the picture. Please make sure that the
sealing-ring is inserted correctly.
4. Rotate the thermometer until the temperature can be easily read.
5. The thermometer is now ready for use.
8. Use
• During the shower, the water temperature is displayed.
• If the water temperature is ≥ 41°C, a LED warning lamp lights up on
the display.
• When the thermometer is not in use, the power saving mode is acti-
vated and the thermometer switches off (ca. 60 minutes).
• To deactivate the power saving mode, move the thermometer and
the temperature reappears on the display.
9. Care and maintenance
• Clean the thermometer with a soft damp cloth. Do not use solvents
or scouring agents.
• Battery replacement: Replace the batteries when the display starts to
fade.
10. Troubleshooting
Problem Solution
➜ Move the thermometer to deactivate
No indication
the power-saving mode
➜ Ensure batteries polarity are correct
(Pay attention to the marking:
+ = positive pole downwards,
- = negative pole downwards)
➜ Change the batteries
➜ Change the batteries
Incorrect indication
9