Operating Informations; Maintenance And Care - Flex XFE 7-12 80 Instrucciones De Funcionamiento

Ocultar thumbs Ver también para XFE 7-12 80:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

XFE 7-12 80

Operating informations

CAUTION
When the power tool is switched off,
the polishing tool continues running briefly.
NOTE
Following a tool change (e.g. wool pad
instead of polishing sponge), the difference
in weight may increase the vibrations.
Change the operating speed with the
adjusting wheel (6) until the vibrations have
been reduced.
– Switch on the machine before placing it
on the surface which is to be polished and
run the polisher up to the set speed.
– Applying light contact pressure, move the
polisher in circular, overlapping
movements on the surface which is to be
polished in order to obtain a good
polishing finish and to ensure that the tool
has a long service life.
– On sensitive surfaces (e.g. car paint-
work) do not work aggressively but work
at slow speeds applying low contact
pressure.
– If using a polishing paste, use the
respective tool for each paste.
– Sponges can be washed in the washing
machine.

Maintenance and care

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always pull out
the mains plug.
Cleaning
Regularly clean the power tool and venti-
lation slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
CAUTION
Risk of injury! Wear safety glases while
using compressed air.
All plastic parts should be cleaned with soft
damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve
or otherwise damage the material.
Brush inspection and lubrication
For your continued safety and electrical
protection, brush inspection and
replacement on this tool should ONLY be
performed by an authorized service center
for FLEX Power Tools.
At approximately 100 hours of use, take or
send your tool to your nearest authorized
service center for FLEX Power Tools to be
thoroughly cleaned and inspected; worn
parts replaced; and when necessary,
relubricated with fresh lubricant if required;
reassembled with new brushes; and
performance tested.
Any loss of power before the above
maintenance check may indicate the need
for immediate servicing of your tool.
DO NOT CONTINUE TO OPERATE TOOL
UNDER THIS CONDITION.
lf proper operating voltage is present, return
your tool to a FLEX authorized service
center for immediate service.
Instruction manual
13

Publicidad

Tabla de contenido
loading

Tabla de contenido