Using A Computer To Operate Your Sign - Adaptive BETAbrite 1036 Serie Manual De Programación

BetaBrite Programming Manual (pn 9703-6020)

Using a computer to operate your sign

Messages can also be programmed into the sign using a computer. To
do this, you'll need special connectors and computer software, either
AlphaNET or BetaBrite Messaging Software. Follow the instructions that
come with the software CD to program messages.
NOTE: A BetaBrite sign can only be connected to one computer. It can not be
networked to more than one computer or to another BetaBrite sign.
NOTE: Use only the power supply (Item D) that came with the sign. Set it flat, so that
it's not dangling by the cord. Do not fasten it to anything.
NOTE: Connecting a surge protector between the electrical outlet and the sign is highly
recommended. Message data can be lost or the sign could be damaged by
power fluctuations.
NOTE: Electrostatic discharge, or carpet shocks, can also cause data loss and damage
to the sign. Avoid touching the sign after it's been installed, especially in cold,
dry winter air.
NOTE: Do NOT connect a telephone to the sign's RS232 jack and do NOT try to
substitute ordinary telephone wire for any parts listed below.
Item Part #
A —
1088-8625
B
1088-8627
4370-0001C
C
1088-9108
D —
1102-9102
E
1092-7827
14
To the sign's
RS232 jack
(on the side)
Ferrite (ferrite end towards sign), supplied with data cable
25-foot 6-conductor RS232 data cable
50-foot 6-conductor RS232 data cable
25 pin sub-D/to 6 pos. RJ11 adapter
9 pin sub-D/to 6 pos. RJ11 adapter
Power supply
BetaBrite Messaging Software
AlphaNET software
B C
A
To one of
the PC's
(RS232)
Description
November 4, 2003
PC running
BetaBrite
Messaging
COM
Software or
AlphaNET
ports.
software
Installation