Setting A Sign's Password - Adaptive BETAbrite 1036 Serie Manual De Programación

BetaBrite Programming Manual (pn 9703-6020)

Setting a sign's password

You can set a personal password to protect your messages and
graphics from tampering by others.
If you forget the password, see "What to do when you forget a sign's
password" on page 19.
Step When you do this . . .
1 Press PROGRAM.
2 Press BACK until SET PASSWORD appears.
3 Press ADV.
4 Press Y to set a password.
Type a 6-character password. (Only asterisks
will appear on the sign as you type.)
Re-type the password when prompted.
5
CORRECT will appear if you entered the same
password.
If you failed to type the same password,
ERROR will appear, and you'll have to start
over from Step 1.
6 Press RUN twice.
Press Y to password protect the sign
7 NOTE: If you select N, then a password will
not be needed when you press
PROGRAM.
18
You see this . . .
PROG TEXT A
SET PASSWORD
SET PASSWORD? Y/N
ENTER 6 CHAR'S
******
RE-ENTER THE 6
THEN
******
THEN
CORRECT
THEN
PROG TEXT A
PASSWORD RUN? Y/N
SECURE
The sign will return to normal operation.
Now, whenever you press PROGRAM, you'll
have to type the password you just entered.
November 4, 2003
Basic sign operation