Olsson and Brothers STROOT SPECTRE Manual De Usuario Y Garantía página 26

EN
If you notice any vibration of the handlebars, check the screws of the folding
mechanism, use the M5 hex key to lock the two screws in the folding mechanism.
Nota: En caso de que la batería presente daños debido al gua, colisión u otro uso
INSTRUCTIONS FOR USE THE E-SCOOTER
• Switch on the scooter and check the battery level.
• Place one foot on the scooter platform, the other should be behind.
• To make the scooter move, with your foot push it against the ground and then
place it behind the front foot.
• Only when both feet rest on the scooter platform, you can press the ac- celerator.
Be careful not to accelerate sharply.
• To reduce the speed, you must press the accelerator in opposite mode, or brake
with the brake handle. This e-scooter incorporates a double brake system, electric
and brake disc, which act together through the brake handle located on the
handlebars.
• The E-scooter incorporates the E-ABS System, not locking the front wheel when
braking to avoid skidding.
• For emergency braking, you must press the brake lever on the left side.
ADJUSTING A BRAKE DISC
If the brake handle is too tight: use a hexagonal key and slide the screws coun- ter-
clockwise on the brake disc tension pulley, shorten the length of the brake cable
slightly and tighten the tension pulley. If you think that the brake handle has a lot of
travel, loosen the tension pulley, pull the brake cable to slightly in- crease the length
of your tail. Tighten a tension pulley.
The performance and parameters of the scooter may be subject to changes caused
by variables such as user weight, slopes, activation and deactivation of the engine at
the push, pavement condition...
26