Cleaning And Maintenance; Service Centre - Max 55240 Manual De Instrucciones

Checking and � lling the lubricating grease
Position the rotary hammer horizontal.
Unscrew the lubricant cover (3) using the
accompanying spanner (13). Make sure you
do not lose the seal.
Top up the lubricating grease if necessary.
Without lubricating grease, the rotary
hammer may be permanently damaged.
Replace the lubricant cover.
Use
Connect the rotary hammer to mains
electricity.
Start the rotary hammer by pressing the
on/off button (5).
If you have selected the chiselling function,
place the accessory against the workpiece
before switching on the rotary hammer.
Note that the rotary hammer vibrates heavily
when the chiselling function is selected!
Hold the rotary hammer steady against the
workpiece, but do not press too hard. The
action of the rotary hammer will usually
be suffi cient to do the job. If this is not the
case, you will probably have to use a more
powerful tool.
Stop the rotary hammer by releasing the
on/off button.
NB! If the rotary hammer has been stored
at a temperature close to or below freezing
point, the lubricating grease may be so thick
that the chisel cannot move backwards and
forwards. Run the rotary hammer unloaded
for 5 minutes to warm up the lubricating
grease before you start work.

Cleaning and maintenance

Wipe the rotary hammer using a well-wrung
cloth after use, and always keep the surface
and ventilation slots free of dirt.
Never use corrosive or abrasive cleaning
agents, as they may attack the plastic parts of
the rotary hammer.
Check the lubricating grease before each use
and top up if necessary.

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• www.schou.com
GB
27