Removing/Replacing The Pourer Sieve; Storage; Troubleshooting - Silvercrest SWKCD 3000 A1 Instrucciones De Uso

Removing/replacing the pourer sieve

1) Open the lid.
2) Pull the pourer sieve 6 upwards out of its holder.
3) Clean the pourer sieve 6 with a lightly moistened dishcloth and under running
water.
4) After cleaning it, replace the pourer sieve 6. Ensure that the restraint
engage and that the pourer sieve 6 is fi rmly seated.
NOTICE
Should the scale deposits in the pourer sieve 6 be fi rmly established, lay
►
it in a water-vinegar solution having a ratio of 6:1 for a few hours. The
scale deposits will dissolve themselves. Rinse the pourer sieve 6 with lots
of clear water.

Storage

■ Allow the appliance to cool down completely before putting it into storage.
Wind the power cable around the cable winder 4 under the base 3.
■
■ Store the appliance at a dry location.

Troubleshooting

Problem
The appliance
does not function.
The ON/OFF
switch 2 does
not engage.
SWKCD 3000 A1
Cause
The plug is not inserted into
a mains power socket.
The appliance is not
switched on.
The appliance is defective.
The kettle is not on the
base 3.
The appliance is defective.
Remedy
Insert the plug into a
mains power socket.
Switch the appliance on.
In this case, contact
Customer Services.
Place the kettle on the
base 3.
In this case, contact
Customer Services.
GB
33