Starting The Device; Connecting The Parent Unit; Connecting The Baby Unit; Connecting Baby Unit And Parent Unit - NUK Eco Control Audio 530D+ Instrucciones De Operación

Light
Display 17
Note: Always connect the cables before
inserting the mains adapter into the socket.
4.1 Connecting the parent
unit
The parent unit is powered by the supplied
rechargeable LiPo battery. This can be
charged using the supplied mains adapter.
Caution! To prevent malfunctions, first
insert the battery into the parent unit and
then connect the mains adapter to the
parent unit.
1. Remove the battery cover 14 on the back
of the parent unit 12, by sliding it
downwards.
2. Put the battery in its compartment as
indicated on the unit. Make sure you
insert it with the correct polarity (+ and -).
3. Slide the battery cover 14 back onto the
parent unit 12.
4. Insert the small plug of the mains adapter
into the mains adapter socket 26 of the
parent unit.
5. Insert the plug into a power socket that
matches the rating given in the technical
data (see "9. Technical
page 45).
6. Initially, charge
continuously for 10 hours to activate the
full battery capacity (see "4.4 Power
supply" on page 34).
Parent unit
Display

4. Starting the device

data" on
the parent unit
Shows the selected volume level. The
more bars you can see the higher the
selected volume
Loudspeaker symbol with no bars: The
device is muted.

4.2 Connecting the baby unit

Note: Don't install the baby unit 1 until the
battery of the parent unit 12 is fully charged.
1. Put the baby unit 1 somewhere in the
nursery where your baby will not be able
to reach it.
An optimal distance between baby and
the baby unit is from 1 to 2 m.
Note: Since the temperature sensor is
inside the baby unit it is important that
you do not cover it or place it near any
heat source. Direct sunlight may also
affect the reading.
2. Insert the mains adapter plug into the
socket 4 of the baby unit 1.
3. Insert the plug into a power socket that
matches the rating given in the technical
data (see
page 45).
4.3 Connecting baby unit and
parent unit
1. Use the On/Off button 8 to switch the
baby unit 1 on. Keep the button pressed
for a moment until the Power LED 10
lights up.
2. Use the On/Off button 19 to switch the
parent unit 12 on. Keep the button
pressed for a moment until the LED 20
lights up green.
The connection
automatically. While this is being done
the connection indicator 18 will light up
red.
33
Meaning
"9. Technical data"
will be
on
set up