Torch; Cleaning And Care; Cleaning; Changing The Battery - NUK Eco Control Audio 530D+ Instrucciones De Operación

Display Significance / Action
HI The temperature has risen above
flashing the upper threshold of 35 °C.
The room temperature has
reached an extremely critical
level and urgent action is
required to reduce the
temperature in the nursery.

7.1 Cleaning

Warning! To avoid the risk of
electric
damage:
– Always disconnect the mains
adapter from the power socket
before cleaning the device.
– Never immerse the individual
parts in water.
Caution! Under no circumstances use
abrasive, corrosive or scratching cleaning
agents, as these could damage the device.
1. If necessary, wipe the individual parts
with a damp cloth.
2. Only use the baby monitor again when all
the parts have fully dried out.

7.2 Changing the battery

The installed 3.7V 1200 mAh lithium polymer
battery (LiPo) may be replaced only by a
genuine replacement battery as used by us.
If necessary please contact our Product
Service (see "Product service babyphone in
Europe" on page 143).
1. Remove the battery cover 14 on the back
of the parent unit 12, by sliding it
downwards.
2. Remove the defective battery.

7. Cleaning and care

shocks, injuries

6.13 Torch

The built in torch will help you find your way
in the dark without switching on the
overhead light and possibly disturbing your
baby.
1. You switch the torch on by holding down
the Torch
4 seconds.
The torch 13 lights up.
2. You switch the torch off by again holding
down the Torch on/off button 25 for
4 seconds.
The torch 13 goes out.
3. Put the new battery in its compartment
as indicated on the unit. Make sure you
insert it with the correct polarity (+ and -).
and
4. Slide the battery cover 14 back onto the
parent unit 12.
5. Initially,
continuously for 10 hours to activate the
full battery capacity (see "4.1 Connecting
the parent unit" on page 33).
43
on/off button 25
charge the parent
for
unit