Rowenta X-TREM POWER CYCLONIC RO62 Serie Manual Del Usaurio página 17

RO_ASPIRATEUR_XTREM POWER_RO62_764270-01_764270/01 16/04/14 13:57 Page11
TROUBLESHOOTING
IMPORTANT If you notice that your vacuum
cleaner is not operating as well, before carrying out
any checks, switch it off using the ON/OFF pedal.
If your vacuum cleaner will not start
• The appliance is not plugged in. Check that the appliance is
plugged in correctly.
If your vacuum cleaner has no suction power
• Either an accessory or the hose tube is partially blocked:
unblock the accessory or the hose tube.
• The lid is not properly closed: check that the dust box is well
placed and close the lid.
If your vacuum cleaner has less suction power, is noisy or
makes a whistling noise
• Either an accessory or the hose tube is partially blocked:
unblock the accessory or the hose tube.
• The dust compartment is full: empty it (see CLEANING AND
MAINTENANCE chapter).
• The filtration system is saturated: clean the HEPA filter
capsule (16) (see CLEANING AND MAINTENANCE chapter). If
the problem persists, change the filtration system (see the
CLEANING AND MAINTENANCE chapter).
• Make sure that the dust box (12) is well positioned in the dust
tray housing (11).
• The mechanical power regulator (18a* or 19a*) is open: close
the mechanical power regulator on the butt.
• The electronic power regulator (9) is set at minimum:
increase the power using the electronic power regulator
(unless you are cleaning fragile fabrics).
GUARANTEE
• This appliance is designed for indoor domestic household
use only. In case of professional use, inappropriate use or
failure to comply with the instructions, the manufacturer
accepts no responsibility and the guarantee does not apply.
ENVIRONMENT
In accordance with current regulations, all appliances to
be scrapped must be permanently disabled: unplug the
appliance and cut off the power cord before disposing of
the appliance.
* According to model : These parts are specific to certain
models or they are accessories that can be purchased se-
parately.
If the lid does not close (detector action 14)
• Verify that the HEPA filter case (16) is there and that it is
correctly positioned.
• Make sure that the dust box (12) is correctly positioned in the
dust tray housing (11).
If it is difficult to move the nozzle
• Reduce the power by opening the mechanical power control
on the butt (18a* or 19a*) or by moving the electronic power
control switch (9) towards the MIN position.
• Make sure that the position of the nozzle (22) corresponds to
the floor being vacuumed:
- for rugs and carpets, use the nozzle in the retracted brush
position,
- for parquets and smooth surfaces, use the nozzle in the
exterior position.
If the power cord does not wind completely
• The cord slowed down as it was winding up: pull the power
cord out again and press the power cord rewind pedal.
If a problem persists, take your vacuum cleaner to your local
Rowenta Authorised Service Centre or contact the Rowenta
Customer Service.
• Always read the instructions carefully before using your
appliance for the first time: use that does not conform to the
instructions will release Rowenta from all liability.
Think of the environment!
Your appliance contains valuable materials
which can be recovered or recycled.
Leave it at a local civic waste collection
point.
11
EN