Troubleshooting - Ampro Audiolab LIVE SNAKE 16.8 Manual Del Usuario

7. TROUBLESHOOTING

Problem
Power light doesn't on after the
device powered on.
Ethernet green LED does not
work after plugging a DSS to a
router.
The DSS can not be controlled by
the DSS discovery software.
The green LED of Ethernet port
lights on but without output.
Note: The supplier will not assume responsibility for errors or omissions in the manual. The information
in this manual is subject to change without prior notice.
P. 14
AUDIOLAB Live Snake 16.8 -
English version
Possible Cause
The power outlet or power strip
is not working.
Power cord is malfunctioning.
The router isn't powered on.
The Ethernet cable is broken.
The port on the router not work.
There is no Network Interface
Card (NIC) used to connect to the
CobraNet network.
The DSS is not in the PC control
status.
No signal route to the transmitter. Make sure the transmitter inputs
The output channel of the receiv-
er is not assigned signal.
The transmitter's Tx bundle
number and receiver's Rx bundle
number are different.
The Subcount number is less
than the channel number of the
receiver which you are using.
The value of modeRateControl
for the receiver and transmitter
are different.
Suggested Solution
Try a different outlet or power
strip.
Replace the DSS power cord.
Power in the router.
Try a different cable.
Try plugging the cable into a dif-
ferent port on the router.
Select the card to serve as the
network adapter used in the dis-
covery process from the Network
Adapter.
Set the first three switches of
the DIP switch which on the rear
panel down.
signal.
Make sure the output channel of
the receiver has assigned signal.
Make sure the bundle numbers
of them are the same.
Set the Subcount number no less
than the channel number which
you want to use.
Make sure the values of mode
Rate Control of the receiver and
transmitter are the same.