Installation; Selecting The Type Of Installation - Kuppersbusch KD 674.1GE Instrucciones De Uso Y De Montaje

3.8 - Before carring out any kind of maintenance or cleaning, disconnect the hood from the
mains supply.
3.9 - If the room where the cooker hood is to be used contains a fuel burning appliance such
as a central heating boiler then this must be of the room sealed or balanced flue type.
If other types of flue or appliance are fitted ensure that there is an adequate supply of
air into the room. When the cooker hood is used in conjunction with other appliances
supplied with energy other than electric, the negative pressure in the room must not
exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker
hood.

4 - INSTALLATION

The versatility of the ducting fan unit on this hood enables it to be installed in one of
four different ways:
1 - Air outlet directed upwards (ducting or recirculation fitting).
2 - Air outlet directed towards the wall (ducting fitting only).
3 - Air outlet directed to the right or left (ducting fitting only). For correct installation of
the hood, please proceed in the following stages:
4.1 - Selection of the type of installation
4.2 - Installation of the hood canopy C
4.3 - Installation of the chimney A
4.4 - Ducting or recirculation fitting
4.5 - Electrical connection and testing

4.1 - Selecting the type of installation

1 - Air discharge towards the top
In this case the hood can be used
either in filter mode (fig. 2a) or in
suction mode (fig. 2b).
2 - Air discharge towards the wall
(fig. 3)
In this case the hood can only be
used in suction mode.
3 - Side air discharge, Lh or Rh (fig.
4a-b).
In this case the hood can only be
used in suction mode.
4
4
Part 1 - INSTALLATION INSTRUCTIONS
G
2
2
2a
S07_02
2b
3
3
17