Decommissioning; Troubleshooting - Schneider Airsystems DK 600 ECO Manual De Instrucciones Original

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

10.3

Service the condensate dis-

charger

SCB condensate discharger

The filter screen on the inlet of the conden-

sate discharger must be cleaned during an-

nual maintenance.

1. Loosen the screw fitting on the inlet and

outlet (item 04 + 03) and remove the

discharger from the side.

2. Remove the filter insert (item 07) and

clean.

3. Installation is in reverse order. Make

sure the filter insert and seal are seated

correctly.

4. Check the connections for leaks during

operation.

See Fig. 5a.

Bekomat condensate discharger

The service unit on the condensate discharg-

er must be replaced every year.

Troubleshooting

Observe the safety instructions!

Colour

Problem

Red

Refrigerant condenser is dirty

Ventilator failure

Refrigerant compressor failure

Insufficient refrigerant

Yellow/red

Compressed air flow rate too high

Compressed air supply too warm

Ambient temperature too high

Blue

Excess pressure loss

System frozen

If necessary, contact our service staff, see last page.

1. Press snap-in hook (item 02) and re-

move control unit (item 01).

2. Detach the service unit from the inlet

and outlet (item 04 + 03). Unclip the

housing (item 06) to open.

3. Install a service unit (item 05) compati-

ble with the control unit, check the model

designation and the colour of the snap-in

hook.

4. Check the connections for leaks during

operation.

See Fig. 5b.