Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning
The need for cleaning is dependent on-air quality and water lime content and can therefore vary. But in normal use,
the cleaning interval is 7 to 12 weeks.
•
Disconnect the unit from the mains and wait
about 1min until the fan has stopped.
•
Remove the front door by grasping the
bottom edge and pulling / twitching straight
out.
•
The door is then fully unscrewed by turning
upwards and unlocking
•
Remove the filter cells by gently pulling them
straight up and then placing them in a bucket
or other container during cleaning.
•
Lime particles can get trapped in the filter,
which reduces capillary capacity. Replace the
filters - 180 ° rotated - which will increase the
wetting capacity
•
First remove the level sensor by pulling the
plate bracket straight out, placing the sensor
on the shelf under the fan.
•
Lift the water tank to the rear and gently pull it
straight out.
•
Drain excess water.
•
For cleaning the container and plate details,
use a soft cloth and mild detergent or descaler
/ disinfectant.
•
Reassembly takes place in reverse order.
•
Put the container in place first and then press
the level sensor. Finish by installing filters and
then the front cover.
Publicidad
