Lutron PHPM-PA-DV-WH Instrucciones Para La Instalación página 3

Load Type Capability
Phase-Adaptive Power Module
• Incandescent (tungsten)
• Halogen
• Magnetic low-voltage transformer (iron core)
• Electronic (solid-state) low-voltage transformer
• Neon/cold-cathode
3-Wire Fluorescent Power Module
• Lutron Hi-lume, Hi-lume 3D, Compact SE,
EC5 dimming ballasts, and L3D LED drivers
Switching Power Module
• Incandescent (tungsten)
• Halogen
• LED
• CFL
• Magnetic low-voltage transformer (iron core)
• Electronic (solid-state) low-voltage transformer
• Magnetic and electronic fluorescent lamp ballasts
• Neon/cold-cathode
• HID
• Motor
1
– 1 ⁄ HP at 277 V~
2
– 1/2 HP at 120 V~
Product Compatibility
120 or 220–277 V~ versions of the following
Lutron products may be used to control these
power modules:
• GRAFIK Eye QS control units
• GRAFIK Eye 3000 Series control units
• LP, LCP, GP dimming panels
• HomeWorks QS remote power panels
• HomeWorks QS in-line dimmer
• HomeWorks QS DIN rail power modules
• Energi Savr Node phase adaptive DIN module
• Lutron in-wall neutral wire dimmers; see
approved list in the Dimmers and Switches
Specification Guide (P/N 367-1746) the Lighting
Load Interfaces section at www.lutron.com
Test Load for Short-Circuit
• Turn power OFF.
• Phase-Adaptive/Switching: Connect standard
switch be tween Line / Hot lead and the load wire
to test circuit.
• Fluorescent: Connect standard switch between
Line / Hot lead and the Dimmed Line/Hot and
switched Line / Hot leads of the ballast.
• Turn power ON and check for short or open
circuits.
Phase-Adaptive/Switching
Line/Hot
Neutral
3-Wire Fluorescent
Line/Hot
Switch
Ballast
Neutral
Switch
Load
Orange
Black/Brown
Power Modules 3