Description Of The Leds In The Circuit; Description Of Leds, Dip Switches And Buttons On Board; Travel Programming - Elvox RS16 Manual Para El Conexionado Y El Uso

Central 24 vcc para cancela corredera acto 404d
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
ACTO
N.B.: If the system has no photocells, sensitive edges or stop buttons (the PHC, PHO and STOP inputs must be jumpered with the common, ter-
minal 14), do not activate the photo-test function.
4.7 - Connecting the aerial
to increase the range use cable RG58 to connect the aerial of the flashing light to terminal number 24 and 25 or connect aerial ZL43 as shown in the figure:
ANTShield
15 16

5 - Description of the LEDs in the circuit:

Abbreviation
Description
Alim.
Shows whether there is mains power (lit if there is mains voltage)
Displays the status of the PHC input (terminal 11), if not engaged the red LED remains lit, if not used then jumper between
PHC
terminal COM and PHC
Displays the status of the PHO input (terminal 12), if not engaged the red LED remains lit, if not used then jumper between
PHO
terminal COM and PHO
Displays the status of the STP input (terminal 13), if not engaged the red LED remains lit, if not used then jumper between
STP
terminal COM and STP
Buttons in the circuit
Abbreviation
Description
P/P
Controls opening and closing the gate
PROG
Press to enter travel programming
MEMO RX
Press to enter programming or deletion of remote controls, during travel programming selection of the direction of opening
Preliminary check:
Check the LEDs for diagnosis of the inputs, PHC, PHO, STP and ALIM. must be on.

6 - Travel programming

Procedure for travel programming:
OPENING
APERTURA
EN
9
10
11
12
13
14
Fig. 13
APERTURA
Fig. 14
Fig. 15
19

Publicidad

Tabla de contenido
loading

Tabla de contenido