Installation - Klarstein 10028189 Manual De Usuario

Caution:
In the moving process, ensure that the air conditioning is in the upright position and the
air conditioning should be placed on a fl at surface.
Do not install and use the air conditioning in the bathroom or other humid environments.
Install the window sealing plate assembly
Half open the window, and mount the window sealing plate assembly to the window (as shown in
Figure 2 and Figure 3); the assembly can be placed in horizontal and vertical direction.
Pull various components of the window sealing plate assembly open, adjust their opening distance
to bring both ends of the assembly into contact with the window frame, and fi x various components
of the assembly.
Install the heat pipe assembly
Screw the heat pipe assembly (exhaust fi tting
end) into the exhaust port on the rear panel
(counterclockwise).
Connect the heat pipe to the window sealing
plate.
Install the body
Move the machine with installed heat pipe and
fi ttings before the window, and the distance
between the body and walls or other objects
shall be least 50 cm.
Elongate the heat pipe and snap the fl at end of
the heat pipe joints into the elliptical hole of the
window sealing plate assembly.
The fl at end of the heat pipe joints must be
snapped into place.
The pipe cannot be distorted nor has substantial
turning (greater than 45 °). Keep the ventilation
of the heat pipe unobstructed.

Installation

16