Settings; Setting The Tear Position - Dascom Tally T2365 Guia De Instalacion

Quick Start-en.book Seite 24 Dienstag, 15. September 2009 3:50 15

Settings

Settings

Setting the tear position

24
This section describes how to set the tear position, the first printing line, the print
head gap as well as the font selection and the character density.
If the tear position of the paper is not aligned with the tear edge of the top cover of
the printer, you can adjust it. Inserted paper needs to be torn off if necessary and
retracted to park position.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key. The printer performs a form feed.
The tear edge is located at the front side of the paper output opening.
Press the < (2) or > (3) key to move the perforation to the desired position. Con-
firm the input by pressing the Set (1) key.
Confirm the input again by pressing the Setup key. The printer is reset to the initial
status.
The correction made – a maximum of approx. 1" (2.5 cm) in each direction – will
be retained after switching the printer off. It can be set separately for each paper
path.
Make sure that the set form length corresponds to the actual length of the forms
you are using.
Quick start guide