Setting The First Printing Line (Tof) - Dascom Tally T2365 Guia De Instalacion

Quick Start-en.book Seite 25 Dienstag, 15. September 2009 3:50 15
Quick start guide
Setting the first printing line
(TOF)
You can use the TOF function for setting the position of the first printing line for
each paper source and each menu individually.
Before using the TOF function, you first have to set the tear position (see above).
Swing the rear cover towards the front (see "Printer at a glance", page 5).
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key.
The paper is fed to the position where the bottom edge of the
first printing line
A
printer. The factory setting for the first printing position
(TOF) is 12/72". This is equivalent to the second line from
the top.
Press the < (2) or > (3) key to move the first printing line to the desired position.
You can set values from 0 to 220/72".
12/72" corresponds to a printing line.
Settings
is aligned with the tear edge of the
B
25