Led Display; Lock Function - EAS ELECTRIC ERCLMAJ Manual De Instrucciones

LED DISPLAY

Press LED button
Press this button to turn on and turn off
the display on the indoor unit.

LOCK function

+
Silence function
FP function
Press this button 2 times during one second under HEAT Mode and setting temperature of
º °
17 C/62 F or 20 ºC.
Note:
This function is for heat pump air conditioner only.
Press this button 2 times during one second under HEAT Mode and setting temperature of 17
º
°C/62 F or 20 ºC to actívate FP function.Press On/Off, Sleep, Mode, Fan and Temp. button
while operating will cancel this function.
Press together
same time more than 5 seconds to actívate Lock function.
AII buttons will not response except pressing these two
buttons for two seconds again to disable locking.
Keep pressing Fan button for more than 2 seconds to activate/disable Silence
function(some units).
Due to low frequency operation of compressor, it may result in insufficient cooling
and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean button while
operating will cancel silence function.
The unit will operate at high fan speed (while
compressor on) with temperatura automatically
set to 8º C/46 º F.
Keep pressing this button more than 5 seconds,
the indoor unit will display the actual room
temperatura. Press more than 5 seconds again
will revert back to display the setting temperatura.
Clean
button and
10
Press this button more than
5 seconds(some units)
Turbo
button at the
V.1