SLEEP Function
Press SLEEP button
SET function
• Press the SET button to enter the function setting, then press SET button or TEMP down or TEMP up
button to select the desired function. The selected symbol will flash on !he display area, press the
OK button to confirm.
•
To cancel the selected function, jusi perform the same procedures as above.
•
Press the SET button to scroll through operation functions as follows:
Fresh*(.�) ➔ Follow Me(A) ➔ AP mode('$')
rJ:
lf your remole controller has Fresh button, you can not use the SET button to
select Fresh feature.
FRESH function(,0) (sorne units): When the FRESH function is initiated, the Ionizer/Plasma Dust
Collector(depending on models) is energized and will help to remove pollen and impurities from the air
Follow me function(
The FOLLOW ME function enables the remote control to measure the temperature at its current location and
send this signal to the air conditioner every 3 minutes interval. When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the remote control (instead of from the indoor unit itself) will enable the
air conditioner to optimize the temperature around you and ensure maximum comfort.
NOTE: Press and hold Turbo button for seven seconds to start/stop memory feature of Follow Me function.
• lf the memory feature is activated," On" displays for 3 seconds on the screen.
• lf the memory feature is stopped, "OF" displays for 3 seconds on the screen.
• While the memory feature is activated, press the ON/OFF button, shift the mode or power failure
will not cancel the Follow me function.
9
AP function(
)(sorne units)
Choose AP mode to do wireless network configuration. For sorne units, it doesn't work by pressing the
SET button. To enter the AP mode, continuously press the LED button seven times in 10 seconds.
For the details, please see "sleep operation" in" USER'S MANUAL".
Note: The SLEEP function is not available in FAN or DRY mode.
or
8 ) :
..
coa,
SETTEMP.
-11-
CI 1
<%-111111
11
..
A
•e
V.1