Maintenance And Cleaning; Wear Parts - Oase OptiMax 300 Instrucciones De Uso Y Garantía

4. Fit the hose on the pressure side. (→ Techni-
cal data)
5. Fit the hose on the suction side. (→ Technical
data)
6. Fit the pump to the outside of the aquarium
using the suction cups to ensure that it cannot
move out of position.
COMMISSIONING/START-UP
 B
•
Route the power connection cable such that
it forms a drip loop!
•
Switching on: Connect the unit to the mains.
The unit switches on immediately.
•
Switching off: Disconnect the unit from the
mains.

MAINTENANCE AND CLEANING

If necessary, clean the unit with clear water using
a soft brush.
•
Do not use cleaning agents or chemical solu-
tions. We recommend using OASE PumpClean
for removing calcium deposits.
Replacing the impeller unit
 D
•
Dismantle the filter housing, or bayonet clo-
sure and pressure socket.
•
Remove the impeller unit, clean or replace.
•
Reassemble the unit in the reverse order.

WEAR PARTS

The following components are wear parts and
are excluded from the warranty:
•
Suction cups, impeller unit
- EN -
13