Faqs / Troubleshooting; Warranty; Declaration Of Conformity - VITO PRO-POWER VIRP100 Manual De Instrucciones

EN
Question/Problem
The tool does not start:
� The compressor is off;
� The shut-off valve of the compressed air system
is closed;
� Low air pressure;
� Air leaks in the compressed air hose;
� Closed or clogged air inlet valve;
� Tool has humidity;
� The "ON/OFF" switch is locked;
� Inadequate or inexistent lubrication;
The tool heats up during use:
� Inadequate or inexistent lubrication;
� Misassembled components;

9. WARRANTY

The warranty of this product is two years from the date
of purchase. You should, therefore, keep your proof of
purchase during this period of time. The warranty covers
any manufacturing defect in material or operating, as
well as parts and work needed for their recovery.
Excluded from the warranty the misuse of the product,
any repairs carried out by unauthorized persons (outside
the service center of the brand VITO) as well as any
damage caused by the use of it.

8.FAQS / TROUBLESHOOTING

Solution
� Open the shut-off valve;
� Open the shut-off valve;
� Increase the pressure in the pressure regulator;
� Replace the compressed air hose;
� Clean the filter;
� Drain the pressure regulator cup;
� Ensure the free movement of the "ON/OFF" switch;
� Perform a proper lubrication;
� Perform a proper lubrication;
� Ensure that the components are properly assembled and
tightened;

10. DECLARATION OF CONFORMITY

We declare under our exclusive responsibility, that the
product Meets the following standards or standardisation
documents: EN ISO 12100:2010, EN ISO 11148-
6:2013, EN ISO 11148-5:2012 e EN ISO 11148-7:2012,
according to the determinations of the directives:
2006/42/EC – Machinery Directive
S. João de Ver, January 2, 2019
Central Lobão S. A.
Responsible for the Technical File
19
27