Cleaning Servicing Work; Configuration - SSS Siedle BVPC 850-0 Instrucciones De Empleo

• Full screen
The camera picture is enlarged to
full screen. The tab bar on the right
is not available in this mode.
Cleaning,
Servicing work
Cleaning the display
To ensure that you do not initiate a
function by mistake or change set-
tings when cleaning the panel, you
can disable the touch function for a
short period (10 seconds).
Note
Observe the care instructions in the
section "General instructions".
• Tap the "Display cleaning" symbol
before you clean your indoor device.
If cleaning takes longer than the set
period, tap the "Display cleaning"
symbol again.
Factory reset
Resetting the panel to the as-deliv-
ered status will only affect settings
which you can change at the panel,
such as the ring tones or display
settings.
Programming by the electrical
installer will not be lost.
1 Open the Settings > Installation
menu and touch "Factory setting".
2 Touch "Start".
As soon as the process is concluded,
the menu Settings > Language
appears.

Configuration

The control and switching functions
and the messages must be pro-
grammed by the electrical installer.
The configuration is transferred to
the panel using the SD card.
1 Open the Settings >
Installation > SD card menu.
2 Insert the SD card with the con-
figuration into the card slot.
3 In the "Load installation from the
SD card" area, tap "Yes".
The question "Do you wish to load
the configuration file?" appears.
4 Tap "Yes" to confirm.
Once the transmission is complete,
the confirmation "Configuration
successfully loaded" appears.
5 Tap "OK".
Servicing
Statutory warranty conditions apply.
25