Black and Decker BDP2600 Manual De Instrucciones página 18

PROBLEM
Will not draw Spray wand not in low pres-
chemicals sure.
Chemical filter clogged.
Chemical screen not in clean-
ing solution.
Chemical too thick.
Pressure hose is too long
Chemical build up in chemical
injector.
No or low Worn seal or packing
pressure
(after period of
normal use)
Worn or obstructed valves.
Worn unloader piston.
Water leaking Worn or broken o-ring.
at gun/spray
Loose hose connection.
wand connec-
tion
Water leaking Loose connections.
at pump
Piston packings worn.
Worn or broken o-rings.
Pump head or tubes damaged
from freezing.
Pump Pulsates Nozzle obstructed.
CAUSE
See How to Use Spray Wand
paragraph in the Operation
Section.
Clean filter.
Make sure end of chemical
hose is fully submerged into
cleaning solution.
Dilute chemical. Chemical
should be the same consistency
as water.
Lengthen water supply hose
instead of high pressure hose.
Contact B&D Customer
Service Representative at
1-800-544-6986.
Contact B&D Customer
Service Representative at
1-800-544-6986.
Contact B&D Customer
Service Representative at
1-800-544-6986.
Contact B&D Customer
Service Representative at
1-800-544-6986.
Check and replace.
Tighten.
Tighten.
Contact B&D Customer
Service Representative at
1-800-544-6986.
Contact B&D Customer
Service Representative at
1-800-544-6986.
Contact B&D Customer
Service Representative at
1-800-544-6986.
See Nozzle Cleaning para-
graph in the Maintenance sec-
tion for the correct procedure.
18- ENG
CORRECTION