DANGER: RISk OF FLUID INJECTION AND LACERATION
WhAT CAN hAPPEN
•
Your pressure washer operates at
fluid pressures and velocities high
enough to penetrate human and
animal flesh, which could result in
amputation or other serious injury.
Leaks caused by loose fittings or
worn or damaged hoses can result
in injection injuries. DO NOT TREAT
FLUID INJECTION AS A SIMPLE
CUT! See a physician immediately!
•
Injuries can result if system pressure
is not reduced before attempting
maintenance or disassembly.
DANGER: RISk OF INJURy FROM SPRAy
WhAT CAN hAPPEN
•
Highvelocity fluid spray can cause
objects to break, propelling particles
at high speed.
•
Light or unsecured objects can
become hazardous projectiles.
hOW TO PREVENT IT
•
Inspect the highpressure hose
regularly.
Replace
immediately if it is damaged, worn,
has melted from contacting the
engine, or shows any signs of cracks,
bubbles, pinholes, or other leakage.
Never grasp a high-pressure hose
that is leaking or damaged.
•
Never touch, grasp or attempt to
cover a pinhole or similar water
leak on the high-pressure hose.
The stream of water IS under high
pressure and WILL penetrate skin.
•
Never place hands in front of
nozzle.
•
Direct spray away from self and
others.
•
Make sure hose and fittings are
tightened and in good condition.
Never hold onto the hose or fittings
during op er a tion.
•
Do not allow hose to contact
muffler.
•
Never attach or remove wand
or hose fittings while sys tem is
pressurized.
•
To relieve system pressure, shut off
engine, turn off water sup ply and
pull gun trigger until water stops
flowing.
•
Use only hoses and accessories
rated for pressure higher than your
pressure washer's psi.
hOW TO PREVENT IT
•
Always wear ANSIapproved Z87.1
safety glasses. Wear protective
clothing to protect against accidental
spraying.
•
Never point wand at or spray people
or animals.
•
Always secure trigger lock when
wand is not in service to prevent
accidental operation.
•
Never permanently secure trigger in
pull-back (open) position.
4- ENG
the
hose