Publicidad
Idiomas disponibles
Idiomas disponibles
e.g. Cords marked 14 gauge can carry a higher current than cords marked 16 gauge
therefore when linking extension cords make sure each cords wire gauge matches.
Note: Outdoor extension cords used in must carry the letters "W-A" (USA) or "W"
(Canada)
Check all extension cords for damage before use.
Avoid sharp objects.
Do not position the cord where it could be subject to traffic passing over it.
Symbols
IMPORTANT: Some of the following symbols may be used on your tool.
V..............................volts
A..............................amperes
Hz............................hertz
~.............................alternating current
.../m...................revolutions per minute
.........................class II construction (double insulated)
Kg............................kilograms
No............................No load speed
Specific Safety Rules
1. Wear eye protection.
2. Keep hands out of path of saw blade. Avoid contact with any coasting blade. It can
still cause severe injury.
3. Do not operate saw without guards in place.
Check blade guard for proper closing before each use. Do not operate saw if blade
guard does not move freely and close instantly. Never clamp or tie the blade guard
into the open position.
4. Do not perform any operation freehand. The workpiece must be secured firmly
against the base and guide fence with a vise during all operations. Never use your
hand to secure the workpiece.
5. Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop before moving workpiece or changing
settings.
7. Unplug tool before changing blade or servicing.
8. To reduce the risk of injury, return carriage to the full rear position after each crosscut
operation.
9. Stopper pin which locks the cutter head down is for carrying and storage purposes
only and not for any cutting operations.
10. Do not use the tool in the presence of flammable liquids or gases.
11. Check the blade carefully for cracks or damage before operation. Replace cracked
or damaged blade immediately.
Gum and wood pitch hardened on blades slows saw and increases potential for
kickback. Keep blade clean by first removing it from tool, then cleaning it with gum
and pitch remover, hot water or kerosene. Never use gasoline to clean blade.
10
Publicidad
