General Maintenance - Terratek PSMS10L Manual Del Usuario

3. Raise the arm to its highest position.
4. Remove the screw that holds the guard retraction arm to the blade guard. (Fig.10)
5. Remove the blade bolt cover.
6. Hold blade guard in the up position and press spindle lock, (Fig.17) (Rotate blade
carefully until blade locks)
7. Use hex key to remove the blade bolt (Pt.71) by loosening in a clockwise direction.
Note: This bolt has a left hand thread.
8. Remove outer blade washer (Pt.70) and blade.
9. Clean and lightly oil outer and inner blade washers, do not remove inner blade washer.
10. Replace blade ensuring the teeth are in the correct direction for rotation. The blade
has a direction indicator arrow printed on it, the teeth must always face down.
11. Fit outer blade washer.
12. Depress the spindle lock.
13. Replace and tighten the blade lock bolt using the hex key to secure tightly.
14. Hold rotating lower blade guard and bolt cover in position and re-fit the fixing screws.
15. Attach blade guard retracting arm to the rotating blade guard.
16. Check guard operates freely.
17. Rotate blade carefully ensuring it does not foul the guard.
18. Reconnect to power supply.
19. Switch saw on and off before it reaches maximum speed to check for free running.
Maintenance
WARNING: For your own safety, make sure switch is off and unplugged from the power
source before doing any maintenance or adjustments. Replace the power cord immediately
if it is cut, worn, or damaged in any way.
Accessories
CAUTION: Use only accessories or attachments recommended for use with your Terratek
tool specified in this manual. The use of any other accessories or attachments might pr-
esent a risk of injury to persons. Only use accessory or attachment for its stated purpose.

General Maintenance

1. Keep the air vents free from obstruction and clean regularly.
2. Check regularly for any dust particles entering the grills around the motor and the switch.
Use a soft brush to remove any dust particles. Wear safety glasses to protect your
eyes whilst cleaning.
3. Monitor the dust bag (if equipped) and empty when approximately half full. Always
empty into an appropriate container. REMEMBER: dust can be hot and cause fire.
4. If the cutting tool has become dull, replace it. Dull cutters will cause increased tear-out
and ragged edges on the cuts.
5. Lubricate all moving parts at regular intervals.
6. To clean the body of the power tool, only use a soft damp cloth. Do NOT immerse in
water. A mild detergent can be used but NOT petrol or any alcohol based product.
7. Should the power cord become damaged only allow a fully qualified electrician to
replace or repair.
16