Dry Pick-Up; After Using The Machine; After Use; Transport - Narex VYS 33-21 L Instrucciones De Uso Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 52
If foam appears, stop work immediately
and emty the tank.
Clean the water level limiting device regu-
larly and check for signs of damage.
Before emptying the container, unplug the machine.
Disconnect the hose from the inlet by pulling out the
hose. Release the latch by pulling them outwards
so that the motor top is released. Lift up the motor
top from container. Always empty and clean the con-
tainer and water level limit system after picking-up
liquids.
Empty by tilting the container backwards or side-
ways and pour the liquids into a floor drain or similar.
Put back the motor top to the container. Secure the
motor top with the latches.
Heavy maneuvers can, by mistake, trigger the water
level limiting device. Should this happen; turn off the
machine and wait for 3 seconds to reset the device.
Continue to operate the machine afterwards.
3.8

Dry pick-up

Picking up environmentally hazardous materi-
als.
Materials picked up can present a hazard to
the environment.
Dispose of the dirt in accordance with le-
gal regulations.
Remove the electrical plug from the socket before
emptying after dry pick-up. Release the latch by pull-
ing them outwards so that the motor top is released.
Lift up the motor top from container. Filter: Check
the filters. To clean the filter you can shake, brush or
wash it. Wait until the filter is dry before re-starting
dust pick-up. Dust bag: check bag to ensure the fill
factor. Replace dust bag if necessary. Remove the
old bag. The new bag is fitted by passing the card-
board piece with the rubber membrane through the
vacuum inlet. Make sure that the rubber membrane
is passing past the heightening at the vacuum inlet.
After emptying: close motor top to the container
and secure the motor top with the latches. Never
pick up dry material without filter fitted in the ma-
chine. The suction efficiency of the machine de-
pends on the size and quality of the filter and dust
bag. Therefore - use only Original filter and dust
bags.
4

After using the machine

4.1

After use

Remove the plug from the socket when machine is
not in use. Wind up the cord starting from the ma-
chine. The power cord can be wound up around the
motor top or at the container or placed in the includ-
ed hook, or fastening means. Some variants have
special storage places for accessories.
*) Optional accessories / Option depending on model
OEL=Occupational Exposure Limit
1)
CAUTION
4.2

Transport

Before transporting the machine, close all the
latches.
Do not tilt the machine if there are liquids in the
dirt tank.
Do not use a crane hook to lift the machine.
Do not lift the machine by the trolley handle *)
4.3

Storage

CAUTION
Store the appliance in a dry place, protected
from rain and frost. The machine shall be
stored indoors only.
4.4

Accessory and tool storage

For convenient transport and storage of accesso-
ries or tools, integrated rails are found on side of
machine which allows fastening with straps or other
means. A flexible strap and hooks are included on
back of machine for attachment of suction hose or
mains cable. For instruction see quick reference
guide.
An optional adapter plate
can be installed on top of machine for fastening of
2-point or 4-point storage cases.
Remove the electrical plug from the socket before
installing the adapter plate.
CAUTION
Do not lift machine in adapter plate without
having storage case safely installed. Note the
weight and balance of the appliance in case of
storage. Maximum weight of storage cases is
30 kg.
4.5

Recycling the machine

Make the old machine unusable.
1. Unplug the machine.
2. Cut the power cord.
3. Do not discard of electrical appliances with
household waste.
As specified in European Directive 2012/19/EU
on old electrical and electronic appliances,
used electrical goods must be collected sepa-
rately and recycled ecologically.
5

Maintenance

5.1

Regular servicing and inspection

Regular servicing and inspection of your machine
must be carried out by suitably qualified personnel in
accordance with relevant legislation and regulations.
In particular, electrical tests for earth continuity, in-
sulation resistance, and condition of the flexible cord
should be checked frequently.
In the event of any defect, the machine MUST be
withdrawn from service, completely checked and
repaired by an authorized service technician.
English
with attachment system
*)
*)
39

Publicidad

Tabla de contenido
loading

Productos relacionados para Narex VYS 33-21 L

Este manual también es adecuado para:

Vys 33-71 l

Tabla de contenido