Cleaning And Maintenance - RAWLINK 56692 Manual De Instrucciones

• Turn the venting valve anticlockwise
and allow the car to lower. The more
the valve is opened, the faster the car
will descend. Avoid lowering the car too
quickly.
Anticlockwise: open
Clockwise: closed
jack saddle
24
load
Checking the hydraulic oil
• Turn the venting valve anticlockwise.
Lower the jack saddle fully and remove
the cover plate.
• Unscrew the oil bung and hold the
hydraulic jack vertical with the handle
pointing downwards.
• The oil should reach the bottom of the
hole for the oil bung. If it is not, top up
with clean, fresh hydraulic oil.
• Replace the oil bung and cover plate.
Venting
• Open the venting valve by turning it
anticlockwise.
• Pump the handle quickly several times to
vent the system. Close the venting valve
again.

Cleaning and maintenance

• The hydraulic jack can be wiped with
a damp cloth and a little detergent, if
required.
• Do not use strong, abrasive or corrosive
cleaning agents on the hydraulic jack,
as these may damage the components.
Oil and grease can be removed using
benzine or similar.
• Lubricate all moving parts regularly with
lubricating spray or a light oil and check
the hydraulic oil level before each use.
• Always store the hydraulic jack in its fully
lowered position, so that the hydraulic
cylinder gets the best protection against
rusting.