Bimar VTM310 Folleto De Instrucciones página 12

automatically, to avoid risk of fire, since a fire risk exists if the
applaince is covered or positioned incorrectly.
 Ensure that the fan is switched off from the supply mains before
removing the guard.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you
are unsure, do not use it and ask for qualified professional help. The packing
materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach
of children because they are potential sources of danger. Attention: any stickers
or advertising material applied to the grid removed before using the appliance.
The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
 Before connecting the appliance, check that the voltage shown on the data plate
matches that of your electricity, and that the electric plug is grounded. In the
event of incompatibility between the electric outlet and the plug of the
appliance, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the
wires of the outlet is appropriate for the absorbed power of the appliance. In
general, the use of adapters or extension cords is not recommended; if their use
is indispensable, they must conform to existing safety standards and their
current capacity (amperes) must not be less that the maximum of the appliance.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 Do not place the fan on a shelf and/or near sinks or other container of liquids
(minimum distance of 2 meters) to avoid the risk of it falling in.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a
inclined plane (the appliance could upset).
 Do not place the appliance near an open flame, cooking or other heating
appliance.
 In the event of a breakdown or poor operation, turn the fan heater off and ask
for professionally qualified help.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in
order to avoid any risk.
Attention: the fan can be used only when completely and correctly assembled, that
is complete with its base and protection grid.