Presentation - Hergom COMPACTO C-3/70 N Instrucciones Para Instalación, Uso Y Mantenimiento

1. PRESENTATION

13 12 11
2. INSTALLATION
The form of installing the C.03-N Compat
Fireplace will decisively influence its safety and
correct working order.
It is very important for it to be well installed.
For the correct installation of the C.3.N Compact
fireplace and chimney, we recommend it be done by a
professional.
The C.3.N Compact fireplace gives its heat by
radiation, heating walls, ceilings, etc. directly, although
mainly by heating the air, using the fans it has fitted
inside and taking the heat to the most distant parts of
the room.
2.1
HOT AIR OUTLET POSSIBILITIES.
OUTLET THROUGH THE UPPER FRONT GRILLE (A)
Loosen the screw located in the centre of the grille
next to the sliding handle indicated with the mark (C)
and slide the grille sideways to close and open the
passage of hot air.
OUTLET THROUGH THE HOOD (B)
This option is not compatible with (A), and although the
diagram is show with outlet through the hood, in truth
the collars located in the roof of the Compact fireplace
are designed to take the hot air to adjoining or upper
rooms. If you decide to use this installation, remove the
covers (5) from the hot air collars on the roof of the
Compact Fireplace and cover up the upper grille on the
front (A). The collars on the roof must be connected to
the grilles with flexible metal tubes, preferibly heatproof.
It is wise for holes (normally covered by grilles) to be
placed in brickwork hoods
10 9 8
1. Single body front
1
2. Hot air outlet grille
3. Deflector.
2
4. Inner rear of fireplace
3
5. Fireplace door handle
4
6. Inner sides of fireplace
5 7.
Air inlet grilles
8.
Cinder tray door handle
6
9.
Inside base of fireplace
7
10.
Cinder tray door
11.
Log support
12.
Fireplace door
13.
Outer duct
Below and other at the top to prevent hot air from
concentrating, making natural circulation easier.
1
2
3
4
5
6
7
8
N.B.: When installing metal tubes for smoke evacuation,
make 2 openings in the lower part of the sides
approximately 25x20 cm. and one at the top of the front of
approximately 50x20 cm. to favour, through natural
convection, the outlet of hot air from inside the cavity. Thus,
you will make the most of this heat and avoid possible cracks in
the hood. These holes can be covered with decorative grilles
that do not make the passage of air excessively difficult.
INDUSTRIAS HERGOM, S.A. has this type of grille
available and can supply them optionally where
required.
15
1- Chimney pipe
2- Hot air grille
3- Flexible metal tube
4- Metal clamp
5- Hot air collar covers
6- Hot air collar
Ø 125mm.
7- Collar and cover
securing screw
8- Chimney collar
of