Display Angle Adjustment; Subwoofer On And Off; Adjusting Volume/Balance; Right)/Fader (Between Front And Rear) - Alpine CDM-7871 Manual De Operación

Display Angle Adjustment

The movable display may be adjusted to 3
different angles depending upon user preference.
1
Press the ANGLE 89 button to adjust the angle
of the movable display.
NOTES
• The display will close a half minute after the ignition
key is turned to the OFF position.
• The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the power
is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.

Subwoofer On and Off

1
Press and hold the SETUP button for at least 3
seconds.
2
Press the g DN or f UP button to select
the Sub-w mode.
3
Press the BAND button to select Subwoofer ON
or OFF.
4
After setting is completed, press the SETUP
button to return to normal mode.
NOTES
• Initial mode is "Subwoofer ON."
• Set to "Subwoofer OFF" unless the subwoofer is used.
• When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer to
the Adjusting Volume/Balance/Fader.
Movable display

Adjusting Volume/Balance

(Between Left and Right)/Fader
(Between Front and Rear)
1
Press the MODE (Audio Control) knob
repeatedly to choose the desired mode.
Each press changes the modes as follows:
→ VOL → BAL
NOTES
• If the 5 5 5 5 5 or 6 6 6 6 6 button is not pressed in 5 seconds after
selecting the BALANCE, or FADER mode, the unit
automatically returns to the VOLUME mode.
• If the subwoofer or BBE modes are ON, their levels
can also be adjusted using the MODE button.
2
Press the 5 5 5 5 5 and 6 6 6 6 6 buttons until the desired
sound is obtained in each mode.

Audio Mute Function

Activating this function will instantly lower the
volume level by 20 dB.
1
Press the MUTE button to activate the MUTE
mode. The audio level will decrease by about
20 dB.
Pressing the MUTE button again will bring the
audio back to its previous level.
→ FAD
5
-EN